AC Power Supply 12V/2A - Europe

Switching wall mount power supply. Output voltage 12V, Output current 2A, Power 24W, Wide range input 90-264V, Plug W2E for use in Europe. Output Connector 2.1x5.5, Cable length 1.8 m.
Voltage DC12V
Loading0 to 2A
OCP3.5 to 5.5A
OVP max16V
Max. Power24W
Ripple & Noise120mV p-p
Connector UL Approved2.1 x 5.5 x 11mm
Voltage90 to 264 VAC
Frequency47 to 63 Hz
Current1A rms@ AC low line input and DC output full load
Inrush Surge Current (cold start)40/60A max. @ power supply cold start, ambient temperature 25°C @115Vac/230Vac nominal AC input.
Leakage current<0.25 mA @ 240VAC input
Over load OCPFold back
Over Voltage OVPVoltage limiting
Short CircuitYes, Output to Ground, Auto recovery when fault has been removed. Short Current & Over Current can not exceed 8A max. after 1 minute at nominal line input.
Protection classII
No Load OperationYes, to protect the power supply and system from damage
Dielectric StrengthHI-POT B / I/P-O/P (FG): 3KVAC / 10mA / 1 minute
Set up time3000 ms max. @ AC low line Input & Output full load
Hold-up Time10ms @ AC nominal Input and Output full load
MTBF Qualification500,000 Calculated Hours at 25°C, by Telcordia SR-332
DC cable & connectorStandard length of the cable 1,8m
Efficiency (Normal)>77.6% min. @ 240VAC input & Full load
Efficiency levelV
Power ConsumptionMax. 0.3W @ AC nominal Input and Output min. load – ERP IV. / ERP V has <0.3W
Input Fuse1A protected against power line surges and any abnormal conditions
Temperature0 to 40°C
Humidity8 to 90% RH non condensing
StandardsCE | GS | CB | cULus | FCC | CCC | KC | SAA | RCM
CE-LVD2014/35/EU; EN 60950-1:2006+A11+A1+A12+A2
Size and Weight
Shipping Weight 75 x 34 x 43mm / 160g